Difference between revisions of "Millimeter-Scale Contact Printing of Aqueous Solutions using a Stamp Made out of Paper and Tape"

From Soft-Matter
Jump to: navigation, search
(Materials and Methods)
Line 5: Line 5:
 
==Materials and Methods==
 
==Materials and Methods==
  
Devices were assembled with layers of patterned paper attached by layers of double-sided tape. "Ink", aka, the reagents of interest, flows from the rechargeable reservoir in the bottom paper layer. The ink then wicks through the sequence of paper layers, finally assuming the desired pattern atop the stamp. Printing is achieved by pressing the stamp to a fresh substrate, delivering the desired reagents. Figure 1 shows the layout of an example device.
+
Devices were assembled with layers of patterned paper attached by layers of double-sided tape. "Ink", aka, the reagents of interest, flows from the rechargeable reservoir in the top paper layer. The ink then wicks through the sequence of paper layers, finally assuming the desired pattern on the stamp. A plexiglass piece provides mechanical support for the stamp. Printing is achieved by pressing the stamp to a fresh substrate, delivering the desired reagents. Stamps produce as many as 40 prints before recharging the reservoir, and one prototype was found to print 500 times without noticeable degradation. Test inks and substrates were "aqueous solutions of small molecules, proteins, and nucleic acids in different shapes and patterns on a wide variety of substrates including paper, glass, polystyrene (PS), nitrocellulose (NC) membranes, cellulose acetate (CA) membranes, hydrophilic polyvinylidene fluoride (PVDF) membranes and thin-layer chromatography (TLC) plates made with silica gel (as shown in ESIf )." Figure 1 shows the layout of an example device.
  
 
[[Image:GW2-1.png ]]
 
[[Image:GW2-1.png ]]
 +
 +
To test the quality of the printed patterns, circles were printed on chromatography paper using low-molecular-weight aqueous dye solutions. Circular spots
 +
 +
 
[[Image:GW2-2.png]]
 
[[Image:GW2-2.png]]
  
 
==Conclusions==
 
==Conclusions==

Revision as of 02:08, 25 October 2011

Introduction

The Whitesides lab has devoted great effort to develop paper-based microfluidic technology. Previous work adapted a commercial printer to achieve micro-scale resolution and accurate reagent delivery, the present paper demonstrates printing with using a low cost, easy-to-assemble device. The technology is equipped to deliver aqueous reagents with millimeter scale resolution. Applications include low cost medical diagnostic devices.

Materials and Methods

Devices were assembled with layers of patterned paper attached by layers of double-sided tape. "Ink", aka, the reagents of interest, flows from the rechargeable reservoir in the top paper layer. The ink then wicks through the sequence of paper layers, finally assuming the desired pattern on the stamp. A plexiglass piece provides mechanical support for the stamp. Printing is achieved by pressing the stamp to a fresh substrate, delivering the desired reagents. Stamps produce as many as 40 prints before recharging the reservoir, and one prototype was found to print 500 times without noticeable degradation. Test inks and substrates were "aqueous solutions of small molecules, proteins, and nucleic acids in different shapes and patterns on a wide variety of substrates including paper, glass, polystyrene (PS), nitrocellulose (NC) membranes, cellulose acetate (CA) membranes, hydrophilic polyvinylidene fluoride (PVDF) membranes and thin-layer chromatography (TLC) plates made with silica gel (as shown in ESIf )." Figure 1 shows the layout of an example device.

GW2-1.png

To test the quality of the printed patterns, circles were printed on chromatography paper using low-molecular-weight aqueous dye solutions. Circular spots


GW2-2.png

Conclusions