Insoluble monolayers

From Soft-Matter
Revision as of 08:16, 3 November 2008 by Mumukeu (Talk | contribs) (Description of insoluble monolayers)

Jump to: navigation, search

Back to Topics.

Insoluble monolayers

Gaines, Fig. 3.4
Morrison, Fig. 12.2
Morrison, Fig. 12.3
Morrison, Fig. 12.4

Description of insoluble monolayers

There exists a wide range of surfactants with an amphiphilic nature which drastically lower the surface tension of water. Many of these amphiphilic substances insoluble in water can with the help of a volatile and water insoluble solvent easily be spread on a water surface to form an insoluble monolayer at the air/water interface. These monolayers, also called Langmuir (L) films, represent the extreme case when considering adsorption to interfaces because all molecules are concentrated in a one molecule thick layer at the interface. The amphiphilic nature of the surfactants dictates the orientation of the molecules at the interface (air/water or oil/water) in such a way that the polar head group is immersed in the water and that the long hydrocarbon chain is pointing towards air, gas or oil.

A schematic illustration showing a spread monolayer at the air/water interface.

The hydrocarbon chain of the substance used for monolayer studies has to be long enough in order to be able to form a insoluble monolayer. A rule of thumb is that there should be more than 12 hydrocarbons or groups in the chain ((CH2)n, n > 12). If the chain is shorter, though still insoluble in water, the amphiphile on the water surface tend to form micelles. These micelles are water soluble, which prevents the build-up of a monolayer at the interface. On the other hand if the length of the chain is too long the amphiphile tends to crystallize on the water surface and consequently does not form a monolayer. It is difficult to determine the optimal length for the hydrocarbon chain because its film forming ability also depends on the polar part of the amphiphile. Furthermore, the amphiphile has to be soluble in some organic solvent which is highly volatile and water insoluble (chloroform or hexane is commonly used).



Back to Topics.

Langmuir-Blodgett films

The history of Langmuir-Blodgett (LB) film started in 1774 when Benjamin Franklin reported to British Royal society:

"At length at Clapman where there is, on the common, a large pond, which I observed to be one day very rough with the wind, I fetched out a cruet of oil, and dropped a little of it on the water. I saw it spread itself with surprising swiftness upon the surface. the oil, though not more than a teaspoonful, produced an instant calm over a space several yards square, which spread amazingly and extended itself gradually until it reached the leeside, making all that quarter of the pond, perhaps half an acre, as smooth as a looking glass."

What Franklin didn’t realize, is how the thickness of the oil on the water surface is on the order of nanometers!

Irwing Langmuir, however, was the first to perform systematic studies on floating monolayers on water in the 1910s and 1920s. The first detailed description of sequential monolayer transfer was done later by Katherine Blodgett. These monolayer assemblies are called Langmuir-Blodgett films. Langmuir was awarded the Nobel Prize in Chemistry much later in 1932.

Interest in LB films have grown significantly only half a century later as a result of Hans Kuhn and colleagues’ work on energy transfer in multilayer system. This started the field of molecular engineering, i.e. Using LB techniques to position certain molecular groups at precise distances to others.

One of the current researches in LB films is the construction of LB-film memory chip in which each data bit is represented by a single molecule.

Morrison, Fig. 12.1
Morrison, Fig. 12.7





Back to Topics.