Controlling the Fiber Diameter during electrospinning
Zach Wissner-Gross (April 21, 2009)
Controlling the fiber diameter during electrospinning
Sergey V. Fridrikh, Jian H. Yu, Michael P. Brenner, and Gregory C. Rutledge
Physical Review Letters, 2003, 90, 144502
Soft matter keywords
Electrospinning, surface tension, scaling
Fridrikh et al. derive an analytical model of the forces involved in electrospinning . In the process of electrospinning, a polymer fiber is created by ejecting the polymer in a solvent between two plates of opposite electric charge. When the plate voltages are high enough, electrostatic forces dominate forces due to surface tension, so that the polymer develops a very high aspect ratio (i.e., becoming a thin fiber) as it streams toward the opposing plate.
Electrospinning is further complicated by the "whipping instability," in which the electrospun fiber coils around itself. In their model, the authors are able to calculate the minimum possible fiber radius (for a thin viscous jet) before the whipping instability breaks the jet up into droplets (as in electrospraying ).
Their main result is that this terminal radius <math>h_t</math> scales as:
where <math>Q</math> is the flow rate of the polymer solution and <math>I</math> is current (due to the net downward motion of the fiber, which is simultaneously whipping around in circles). Figure 1 shows a log-log plot of <math>Q/I</math> vs. <math>h_t</math>, which we would expect to have a slope of 2/3. The fitted line, with a slope of 0.639, corresponds well with their theory, and the offset in the log-log plot suggests that the authors' electrospun fibers could be reduced in size by a factor of two but no more.
Soft matter discussion
The physics in this article is all derived from the authors' Equation 1, which I reproduce here in Figure 2.